The CLT agitator-pump with its small size, is an economic pump that can be installed inside small refrigerators where compact dimensions and low performances are required.
>> Request Technical Details
>> Power cords available
>> Technical specification
Technical specification
Pump | AGITATOR-PUMP with immersed vertical axis. |
Windings | Single-phase motor with Class F. |
Motor body | Naked |
Protection | IP XX degree of protection from liquids seepage. |
Safety | Built-in thermal motor protection system. |
Ball bearings | Ø 8mm NSK, SKF or equivalent, in semi-rigid and noise-insulated silicone casing. |
Motor shaft | AISI 303 INOX steel Ø 6mm. |
Fastening parts | INOX steel or anti-oxidant materials. |
Motor parts | — |
Cooling system | Air cooled pump with a suction speed of 1,2 m/second. |
Water connection | Compatible with John Guest fittings. |
Operation | Power supply 220 & 230Volts – 24 hours a day non stop. |
Regulations | Complying to EN60335-2-41 and WEEE/RoHs directives. |
Note | Read the instruction manual for correct set up and use. |
![clt-grafico](http://www.saberpumps.com/wp-content/uploads/2013/04/clt-grafico.png)
TYPE | Volt | Hz | Amp | Watt | Rpm | A | B | C | Propeller (8mm) | Weight |
CLT-2 | 230 | 50 | 0,21 | 27 | 2500 | 64 | 150 | 52 | 45 2 Blades 15° | 0,98 |
Performance and electrical data has been tested at 0°C with clean water only.